The aquaero is an absolutely autonomous working microprocessor-controlled device with USB 2.0 interface. The LT version has no screen but retails all of the features that the software offers.

The aquaero is an absolutely autonomous working microprocessor-controlled device with USB 2.0 interface. The Pro version has the benefits of the screen

This temperature sensor has a G1 / 4 thread and can be used with any hoses with suitable connectors. The sensor has a 60cm connection cable and a two-pin plug.

The aquaero is an absolutely autonomous working microprocessor-controlled device with USB 2.0 interface. The XT Version comes with a touch control system

Replacement bezel for an Aquaero 5 PRO. The Aquaero 5 PRO ships with a stainless steel bezel, using this black anodized aluminum bezel, the aquaero perfectly matches any black PC case.

Replacement bezel for an Aquaero 5 XT. The Aquaero 5 XT ships with a stainless steel bezel, using this black anodized aluminum bezel, the aquaero perfectly matches any black PC case.

Aqua Computer Aqua remote infrared remote control for aquaero 5

Support system for Aquabox Resevoir

This connection cable can be used for aquabus connection between Aqua Computer devices or for connecting a RPM signal output to a suitable fan connector.

This material kit allows the installation of a aquaero 5 LT (not included) drive bay into a free 5.25 inch. A front panel is not included here, the existing housing panel continue to be used.

Mounted on an aquaero 5 controller, this passive heat sink improves the heat dissipation and thereby increases the maximum power output of the fan channels.

Mounted on an aquaero 5 controller, this water block improves the heat dissipation and thereby significantly increases the maximum power output of the fan channels.

The poweradjust 2 is optimized primarily for the control of Laing DDC pump, but other consumers with up to 25W continuous power at 12 volts can be connected to the controller.

This plug can be used to connect cables to the aquaero 5