This pump is the first pump worldwide which is used in mass-produced water cooled workstations and is ideal for the watercooling of processors and electronic components. Due to its compact size and its power it can be used for many applications.
This DC pump is an electronically commuted ball motor pump with an estimated lifespan of more than 50.000hrs at 12V. The only moving part on the pump is the spherically shaped Rotor unit which is sitting on an ultra-hard, wear-resistant ceramics bearing ball.
A conventional shaft with bearings and seals is not used or needed. The spherical bearing of the rotor unit on the ceramics bearing ball has many advantages: The development of bearing clearance is technically impossible which results in the impossibility of noise level increase over the lifespan of the pump. The bearing is self-adjusting, making the pump consistently quiet in operation over the full lifespan. The pump is directly lubricated by the coolant (wet-running pump). Therefore no maintenance is required.
As the rotor is magnetically held in place even small dirt particles pose no problem for the mechanism, a blocking of the pump is not possible under normal operating conditions. Even after a long period of standstill reliable operation is ensured. The permanent magnetic rotor unit is frictionlessly driven by a magnetic field which is produced by the surrounding stator.
The stator is completely built around the rotor, therefore the pump is with its 38mm only slightly higher than the stator unit. It therefore fits a in almost any PC case, may it be Super tower or Barebone. A separate magnetic shielding is usually not required. The ball motor principle allows powerful yet power-saving operation. The pump can be regulated by power variations of the DC operating voltage over a wide range. All parts in touch with the coolant are completely corrosion free.
- Motor design: Electronically commutated, brushless DC, spherical motor Voltage
- Range: 8 to 13.2 VDC
- 9 VDC required to start
- Motor rated at: 18W
- Max. delivery rate: 600L/h
- Maximum system pressure: 21.75psi, 150 kPa (1.5 bar)
- Temperature range: Up to 140F (60C)
- Corrosion resistant
- 50,000 hours mean time before failure (MTBF)
- Compatible with 3/8" ID Hose
Copyright ï¿½ 2006 - 2014 | www.overclockers.co.uk | Overclockers UK (Ocuk Ltd) | All rights reserved
Company Number 03869866 | VAT Number GB 747 9639 69
All on-line orders are placed via our SSL enabled Secure Server.
* Calls charged at standard rate, contact your service provider for more information.
Lines open 8.30am to 5.30pm Monday to Friday and 9.00am to 5.00pm Saturday
Sales - UK 01782 444455
Sales - International +44 1782 444455
Support - UK 01782 444455
Support - International +44 1782 444455
Systems Support - UK 01782 444455 (Mon-Fri only)
Systems Support - International +44 1782 444455 (Mon-Fri only)
From the UK 01782 565746
International +44 1782 565746
Overclockers UK (Ocuk Ltd)
Unit 5 Lymedale Cross
Lower Milehouse Lane
Staffordshire ST5 9BT