+44 (0)1782 44 44 55
EK-FC1080 Ti GTX Strix Graphics Card Water Block - NickelEK-FC1080 GTX Ti Strix is a high-performance full-cover water block for the ASUS ROG Strix GeForce® GTX 1080 Ti graphics card, based on NVIDIA Pascal™ architecture (GP102).
This water block directly cools the GPU, RAM, and VRM (voltage regulation module) as water flows directly over these critical areas thus allowing the graphics card and it's VRM to remain stable under high overclocks. EK-FC1080 GTX Ti Strix water block features a central inlet split-flow cooling engine design for best possible cooling performance, which also works flawlessly with reversed water flow without adversely affecting the cooling performance. This kind of efficient cooling will allow your high-end graphics card to reach higher boost clocks, thus providing more performance during gaming or other GPU intense tasks. Moreover, such design offers great hydraulic performance allowing this product to be used in liquid cooling systems using weaker water pumps.
The base of the block is made of nickel-plated electrolytic copper while the top is made of quality acrylic material. The top also features two pre-drilled slots for 3mm diodes. The sealing is ensured by quality rubber washers. Screw-in brass standoffs are pre-installed and allow for safe, painless installation procedure.
EKWB recommends the purchase of aesthetic retention backplate (EK-FC1080 GTX Ti Strix Backplate - Black, Nickel) which improves the looks of your graphics cards and also provide some passive cooling to the circuit board VRM section.
G1/4" threaded fittings can be used on both sides of the FC terminal. Up to four EK-FC1080 GTX Ti water blocks can be used on a single ATX form factor motherboard by using EK-FC Terminal (DUAL, TRIPLE or QUAD type) system or other means of interconnectivity. Please note that the old EK-FC Bridge & Link system is not compatible with this water block.
The block also features a special plastic cover over the block Terminal. This add-on is designed to reveal the graphics card model, visible from the side. The terminal cover is removable, it is fitted with 2 screws from the side.
We recommend EK-Cable PWM Fan Adapter for GPU for connecting your GPU to PWM-enabled fans in your custom loop and thus controlling the PWM profiles based on the graphics card temperature.
- EK-FC1080 GTX Ti Strix water block
- Mounting mechanism with screw-in brass standoffs
- Necessary mounting screws, nuts, and washers
- 2x EK plug G1/4”
- 6mm Allen key
- Thermal pads
- Thermal grease EK-TIM Ectotherm (1g)
- ASUS ROG Strix GeForce GTX 1080 Ti OC ROG-STRIX-GTX1080TI-O11G-GAMING 11GB GDDR5X (90YV0AM0-M0NM00)
- ASUS ROG Strix GeForce GTX 1080 Ti ROG-STRIX-GTX1080TI-11G-GAMING 11GB GDDR5X (90YV0AM1-M0NM00)
Due to changes in the PCB design, ASUS ROG Strix GeForce® GTX 1080 Ti graphics cards in the following S/N range are not compatible with EK-FC1080 GTX Ti Strix full cover water blocks:
More links for "EK-FC1080 Ti GTX Strix Graphics Card Water Block - Nickel"
This article is used in:
Graphics Card Edition
EK Water Blocks