Trying to visualise new build - Ethnoo 719

Associate
Joined
28 Oct 2020
Posts
124
Im pretty noob to watercooling, although I have done a simple cpu loop a few years ago.

I've managed to get a cobbled together vis in blender (downloaded models) and jps.

So will this work just component/loop wise?
Will it fit in the 719?

LqsYQRRY

https://postimg.cc/vcQQthGD

https://postimg.cc/LqsYQRRY
vcQQthGD
 
Associate
OP
Joined
28 Oct 2020
Posts
124
why do you have two rads in the bottom? Three is already overkill. Have you though about how you're going to install the tube? Soft or hard?

oh its just to visualise a 54 or 60mm thick rad. I am intending to do hard tubing, mostly 90 degree bends with fittings making the difference on the other end if necessary. If it all gets too much then i'll go for ZMT as backup.
DO you think it would be better to go with Xflow rads?
 
Soldato
Joined
18 Dec 2008
Posts
6,307
Location
Liverpool
Argh, your res is wonky! Wouldn't be able to leave that.

Glad I'm not the only one who thinks that, I don't have much experience with this stuff, I've maybe done four loops but I know you wont get soft tubes looking good if you try to make them straight. It's all about getting sexy curves going. If you want straight runs, go hard line.
 
Associate
OP
Joined
28 Oct 2020
Posts
124
Glad I'm not the only one who thinks that, I don't have much experience with this stuff, I've maybe done four loops but I know you wont get soft tubes looking good if you try to make them straight. It's all about getting sexy curves going. If you want straight runs, go hard line.

I already said I'm using hardtubing. And I figured he was joking about the wonky res: its a jpg on 3d model, and the distro plate is just a jpeg!
 
Back
Top Bottom