Resistor help

Permabanned
OP
Joined
18 Oct 2002
Posts
1,297
Location
Derbyshire
30ma

would it matter if i ran a little more current through it ?
say for example 6 or 9 volts what effect is this likely to have long term ?

i have tested it with both 6 and 9 volts and it workd fine but 12v blew one of these leds

Thanks James
 
Associate
Joined
14 Jun 2004
Posts
1,572
Location
Tilchestune
ok 3 volt led
supply 12 vdc

current though network = 30ma or 0.030 amp

you need to drop 9 vdc

thefore ohms law r = v/I

r = 9 / 0.03

= 300 ohm

wattage of resistor p - v * I
9 * 0.03 = 0.27 w

therfor a half watt 300ohm would do the job

increased current will blow the led quicker and give higher output
 
Permabanned
OP
Joined
18 Oct 2002
Posts
1,297
Location
Derbyshire
thanks for the reply

I have tried the LED in place at 3V and it wont be bright enough but at 6 it is *just* bright enough and at 9V is spot on (using small 3v watch batteries)

but wiring it directly to the cars 12v burnt it out almost straight away
does the amount of increased current decrease the life of the LED on a linear scale ?

eg 3v - life = 50,000 hours
6v - 25,000 hours

if current gives higher output what does the increased voltage do ?
 
Associate
Joined
14 Jun 2004
Posts
1,572
Location
Tilchestune
OK

power ( watts ) is v * I
eg 1 watt = 1 volt * 1 amp

therfore if the resistance remains the same increase the volts will increase the current as well

if you put the volts up to 6 the network ( led + resistor ) will draw 60 ma


BTW you can get 12 vdc leds high intensity ones as well and save you the trouble

RS sell then as do the other electronic component shop they have a store opp. the old Players office in Notts ( now Nat West office )
 
Back
Top Bottom