Vapochill LS testing

Soldato
Joined
15 Jun 2003
Posts
2,591
Location
Darlington
Hi,my rig is still running on air at the moment & would like to know if there is anyway to test the Vapochill to make sure it's working ok before i remove motherboard and install it.

Thanks
 
Don
Joined
7 Aug 2003
Posts
44,275
Location
Aberdeenshire
What you need to do is, jump start the PSU by connecting the green pin to any black pin in the ATX connector. This will power up the Chillcontrol board through the molex. Then all you need to do is short the two pins you connect the case power switch to and that'll start the compressor.

In fact, you could just start your PC with the molex connected to the controller board then short those two pins and that'll start the Vapo.

Jokester
 
Back
Top Bottom