Search results

As does yours mate . Now I wish ocuk would hurry up and ship my block out! Killing me having this beauty just sat on the desk haha

I can finally join the club ;)

Gibbo said 100 next week (but take that with a pinch of salt because of courier issues: lost damaged and so on)

Fellow 600+ friend! Hopefully we're not waiting too long *might be optimistic here* Got the Radeon 6 series fun too haha

Lucky I'm 628 :(

Well I finally managed to put an order in on a 5900x tried between 2-3 with no luck then had to get back to doing work. Hopefully it's not too long a wait at the back of the queue :p

And now they're all gone... Fantastic :(

Sites down RIP no 5900 for me

Wait is it 2pm now? Edit just seen Gibbo's message good job I checked! Best of luck guys!

Yeah it's impossible to do mine on 10%. I don't have any pictures but it's fairly easy to do. You take the pwm control PIN from the pump (pin 4) and connect it to a 5v pin on a molex connect (the one with a red wire) basically sets a 100% duty cycle on the pwm pin so spins at full speed.

Do you have the PWM cable plugged into the motherboard? My mobo sends the PWM signal to ground when the board is not powered ie turns the pump off (been caught out by this). So when filling/ testing the loop I have to unplug the pwm cable from the board which makes it spin at 10%, then I jump...

Is it a pwm one? The pwm if no signal going through them (when filling) will spin at like 10% I have to jump the pwm wire to a 5v molex to bleed the loop otherwise it doesn't get past the first rad. Just seen that switching your block fixed the issue that's odd

The Jotunheim is a great amp had one for about 12 weeks a couple of years ago which sadly broke and returned it (I just got unlucky) but the quality was exceptional. I didn't want to wait for it to be repaired so ended up getting a refund and buying a Myryad z40 with an smsl su-8 (a fantastic...

Top quality ocuk service as normal, a new tilt mechanism is on it's way to me :)

Doing it with me on it, lean all the way back (against the stop) and nothing. Reduce lean pressure and stay in the same place sometimes reduce lean pressure and nearly get launched off it when it clunks and snaps forward.

Hi all, I have had my Hero over a week now mostly I'm really happy with it but have noticed something really annoying/defective with it, I've posted on the CS forum too but wanted to see if you guys have experienced the same issues. The seat base tilting keeps jamming when reclined to max/near...

Nice!! Are these the ones with the springs from a Lamborghini? That were leaked a few months back?

Ok I'm sold on my new hero, it's built like a tank! Seriously engineered can't find any missed/bad stitching or blemishes and installation was easy enough with 1 person (hardest bit was getting it upstairs!). I know what people mean now about it being firm! But it's by no means uncomfortable...

Nice! Might have to get a pair ordered for my new chair ;)

I had the same decision on the weekend I'm 193cm and 90kg so needed something roomy. Ended up going for the PU hero due to the great deal ocuk had on and I prefer the design of it over the titan, plus it's available from ocuk. It got shipped today so should get it tomorrow will give you my first...