The only time i have had the "tightness" in the chest after vaping is when i have chain vaped @ 100+ watts(3 mg) ,i put it down to Nic levels.
I dropped Nic levels to 1.5 mg & no problems .
Have built 2 DNA250c mods & really like the Replay mode.
Did work straight away with tri core fused Clapton.s(2 x ss304 , 1 NI80 wrapped with 40 gauge NI80)
But over the last few weeks have fiddled with it to get the vape more to my liking.
The place in Escribe to change Replay settings for...
DNA & squonk sounds good to me to.
Just bought the gbox 200 & it is a really descent squonk mod but i need something a little bit more.
So getting the stuff needed to build a DNA 250 .Li-Po squonker.
Find the flavour is a tiny bit better in shorty mode(only 18ml :)).
Luckily my big Li-Po mod is 40mm wide so the Titan fits pretty good , can vape all day @ 125w & don't have to charge battery or refill with juice.
Looks very much like the Aromamizer Titan.
Actully besides ridiculously tight AFC & juice control a really descent(but massive)tank.
Got some 4mm I/D Stapleton's in mine ,vapes very similar to the Aromamizer+ but with huge airflow.
The Titan allows me to play with some big coils , triple coils &...
Higher PG.
Could try this https://www.thealchemistscupboard.co.uk/product/flash-e-liquid-enhancer/.
Add menthol or koolada to your eliquid or a combination.
I have 1 of the early Kylin's & yes it is a pain with the condensation/leaking but i also have 1 off the new coloured 1's
& this is night & day better.Also i don't get the problem were i could really struggle @ times to get the top off to fill.
Yup , build the wire ,in the Temp control results(top middle of the page) click on DNA200 & then the Download TFR table as CSV.
Have used this method for 304 SS Clapton's & it worked very well.
Well it is a framed staple coil ,Ohm's out @ .35 about 6 wraps , cannot for the life of me remember what i used to make coil,
just a shortish length of coil i had lying about.
Well i have had mine for a day & it is the best single coil RTA that i have tried.
Got the postless deck on the way but the single coil deck is very good ,wicked using Kendo vape cotton(gold edition)
just pocked the wicks down to the bottom of wick well (3.5 mm framed staple )& no issues , wicks...
DNA 200 / 250 if you look at the spec sheets will fire very low but at a reduced wattage ,IIRC you get a full wattage at .08 resistance but any lower & the wattage is capped.
The latest mod i built fired @ .005 Ohm's :) that was when i was checking mod resistance(1.5mm copper wire in atty) but...
If the 3500mah can be believed then they will take a long time to charge , if they are 3500mah then most probably only a 10amp battery.Not sure what is under the wrapper of the AWT but if the mah is correct then likely to be an LG MJ1 battery but never can really tell with rewraps.
Personally i would not trust the RX200's voltages to much , if it was a DNA then i would be more likely to.
A quick check with a voltmeter would be preferential .
Personally i buy batteries from Torchy on Ebay (get a discount for being on the same forums as him) .
For HB6's , VCT4's etc i buy from AkkuTeile in Germany , why ? because it was 1 of the places that Mooch recommended.
I am sure there are places selling genuine VTC5's or places that believe...
I always use the supplied vape band around the swivel top fill on my Smok tanks , have done since the TFV4.Do not have the TFV8 but do have the TF RDTA & the TF RDA G4 & both do not leak except for user error.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.