Search results

I have replaced the HDD in my Sky HD box a couple of times going to a 500gb drive first then a 1tb drive and used Copy+ to transfer everything over - works very well but if you aint fussed about losing the stuff on anytime until it redownloads then i would suggest you turn off anytime on the box...

I was with Nildram who have recently been taken over by TalkTalk and since the change my connection drops on almost a daily basis as well requiring a router reset - or if you call talk talk and wait an hour getting through they can reset the line from their end and it works so its not the router...

you can go to x42 on the multiplier from what ive seen so id say around 4.2ghz

Order Number: OC1169850

mine still says printed in warehouse :(

i have the steelseries merc stealth and have to say its a big step up from the zboard i was using - would highly recommend in

your probably looking at £150 FOR cpu & gpu blocks (1 of each inc fittings) £70-100 for a rad and fans, £40-60 for a pump and about £20-30 for a decent res. add some tubing for about £25 and a basic setup will cost you around £320 assuming your case is big enough to fit it all in

nope no beeps at all with my main psu and gfx in (the 1 long and 2 short beeps are what i would expect with the naff 430w test psu as it wont power the gpu) And on both occasions it has powered up initially it has run stable for the whole time it was on

Hi All, After purchasing a new cpu, mb and ram last week i put together my new system together and have had the following issue: the cpu and gfx were from my old system and im not convinced they are working correctly but all went together ok powered up prime tested for an hour and half...

buy my gtx295 instead so i can buy a second 1 for my machine :D

The block is brand new - flushed it through before fitting it. I did as earlier how tight should it be as its screwed directly and doesnt use any springs to keep the tension on - over tightening some of the screws cause the board to warp so its just done up to a level where this doesnt...

ok i took it off again last night, removed all the paste and reapplied now im idle at 53c and under full load upto around 68-70c. Dont understand why my temps are so high ? I'll wait now till my DTEK Fuzion cpu block turns up this week and investigate further then

My CPU temps are about the same - dont think i have air in the system as that would affect the load temps more i would have thought ?

im using arctic ceramique paste applied as recommended on their website - have reseated the block already (looks like its making good contact by the way the paste has spread) and its load temps are pretty good as i said it only goes up a couple of degrees under load I might just take it off...

Anyone ?

Howdie Ive just installed an OCZ 8800gtx with an EK Full cover block on it in a loop with my cpu and a pa120.2 rad. Problem i have is the idle temps seem pretty damn high - ranging from 64c - 69c however load temps dont seem to go up more than a couple of degree's from the idle temps...

I currently have a Swiftech Storm cpu block on my q6600 and am looking to upgrade it to a D-Tek FuZion Universal CPU Waterblock - anyone know if i will have to remove my motherboard to fit it or will i be able to use the mounting screws from the Storm ? Dont really want the hassle of removing...

Are both power leads to the graphics card in - built my system yesterday and had the same thing due to the power to the graphics

My first bash Here is my first score after my system build this evening - reckon its got a lot more to give though :) http://service.futuremark.com/compare?3dm06=3460878

:) thats what i was hoping to hear - even if i overclock the cpu quite a bit (its a G0 stepping so hoping to get it up a fair bit)