Yea thats what i meant Thanks !
Ok So memory seems fine, Other things you can do/check are.
The HTT multiplier which should be 3, if its at four then try 3.
The HTT voltage, try raising it a little .1 or .2 of a volt
Chech weather memory is running at the right Volts (should be but your...
CHef...... As i stated in my message...... Will also depend on whether you memory is maxed out too ? if running 1:1 and your memory is decent 3200 to 4000 then maybe the ram is maxed out so try a 6:5 divider or anything lower than 1:1.
In CPU-z What is the Memory running at ? MHz wise ? and...
From my experience with a CAB2E 0545 CPMW i had to use atleast 1.45 volts to get 2.8 and 1.55 volts to get 2.9. The chip maxed out at 2.92 stable with 1.57 volts.
Will also depend on whether you memory is maxed out too ? if running 1:1 and your memory is decent 3200 to 4000 then maybe the ram...
I have two of these..... I can load windows, Pass SuperPi32, OCCT and prime small TFT's at 3.05Ghz.
At 3ghz its will pass all tests including 9hrs+ of Prime95 Blend. This is all at 1.522 Volts (CPU-z reading).
Havent tried anymore voltz but the chip seems to get better over time as it...
Its like a multiplier..... The max you can set the vCore to on the DFI mobo is 1.55 and the Special just increases the vCore by how much you set it at.
ie. vCore set to 1.55 with 110% special would give you 1.705.
Imagine it as TAX on your Vcore :D
Nogs
Yea the same here.....Bios is set to 1.450 with 109.6% special which adds up to 1.5892 but the Bios reading is 1.57 and CPU-Z says its 1.552.
I just go by CPU-Z as MBM and ITE Guardian say the same.
Like i said above m8.
Nogs
Using a Zalman 9500 LED about 44 max on full load and idles at 32. I'm really chuffed as you dont see many later CAB2E's reaching 3gig. Going to try reducing the volts a little once its settled.
CAB2E Success
After a while of contunual testing i have finally hit 3ghz with a CAB2E 0546 UPMW Stepping :D
Thought i'd never get there, 295 x 10 @ 1.55 was the best i could do for a while, the chip wouldn't boot up at any higher even with 1.6+ volts. The memory running on a 9/8 divider. 1 x...
Yea, i run the board 1.6v and the Ram at 2.85 (toastie). Although i only have one stick of 1Gb in slot closest CPU.
MMmmmm I havent read the rulz yet... Changed now :D
Fits lovely, Super cooler this.... 42 on load for me at 2.85 gig and 33 idle.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.