Search results

well if people can fit watercooling into a G chassis (like me, only my res is on top of the case but that’s unecessary as a t-line would be sufficent) a P chassis should be easier but then again may not be. I think i've seen a SN26P watercooled (CPU & 2x GPU) somewhere

i know most intel users have ddr2 ram but most dont have ddr2 ram capable of doing 800Mhz, most intel users will need new ram if there going to use their system to its max. I wont belive these claims till the silicon is out and benched by independent sources! but i wouldn't be surprised...

If u want a conroe you will probably need new ram to use it to its maximum as DDR2-800 will be required to do that

There shouldn't be much of a difference between a 4800+ s939 and 4800+ AM2 part, the speed rating is the same! AM2 isnt a waste of time, it is just AMD moving to a different type of memory(a sideways step), so at the moment there is no difference but the fact that 65nm, low power and probably...

Its not a kit but the parts i've used are: Polarflo TT Gfx & CPU Blocks XSPC Res Danger Den DDC Pump Thermochill 80mm rad mounted internally with a 120mm fan mounted on an adaptor on the back Tygon tubing was a must to get some of the radi needed

Still needs a bit of finishing off trim around the gfx waterblock and a vfd to be put in the front and res attached properly Form Factor: Shuttle Form Factor Manufacturer: Shuttle CPU: Athlon 64 3400+ (Newcastle) RAM: 2x 512Mb Geil 3200 Value HDD(s): 120Gb Maxtor SATA GFX: X850 pro Vivo...

I just attached the adaptor and the fan on the back and removed the shroud inside (dont think that'll make much difference in or out) have you checked you bios or software to ensure the fan is at full speed it could be setup to keep the temp delow 60 or something and therefore run the fan at too...

it'll work fine with just a 120mm fan, my rig was running like this for months before i watercooled it, i i still use it to cool my 80mm rad which is where the ICE normally sits

Try going to configure > advanced select a chip (my mobo uses a 'IT8712F at $290 on ISA') and change 'PWM # mode' to 'software controlled' hope this helps

Just wondering what you guys think of my setup, the case does still fit! (with a hole for the fat gpu block) A few things i need to finish: 1) Make mount for pump 2) Tidy cableing There is a 120mm fan on the back on an adaptor that cannot be seen in these photos My temps are...