Search results

As above, the thicknes (depth) won't be an issue as the added HSF/Cooling Fans will come forward (towards the side panel) and there is about 18cm from the front of my 3090 (all be it mines watercooled). Length shouldn't be an issue unless it is insanely long. The height of the card will be the...

Sounds like EK shifting the blame to customers for their products not always working as intended...?

The gap at the top and the bottom of the case is not identical - so two identical rads looks more out of place to me. Hence why I went one 40 and one 60mm thick rads.

A nice clean build that. Spot on

Nvidia Founders Editions are a lot smaller PCBs than what Asus, MSI etc will produce.

If you are speaking of @jammir 's build then ours are very similar and he has gone for a very clean look. I'm jealous of the purple coolant now. GPU is certainly not small but the 3090 FE with the EK waterblock is quite compact compared to with the heatsink fan assy. It's fairly thick due to I...

^^ this.

EK-CoolStream XE 360 at the top is 60mm (plus 25mm fans) EK-CoolStream PE 360 at the bottom is 45mm (plus 25mm fans) Front facing is all 16mm Acrylic hard tubing, around the back is EK-ZMT for ease. I hard line tubed the hidden bits on my old TJ-07 build and vowed never again lol.

It is around the rear - I haven't finished this yet so there is still some cable management but here is a sneak peak. The display port cables having to run internally was something I did not think of sooner and that became a real pain in the butt with the vertical GPU mount.

edit: I am 98% complete, I just need to figure out how to finish the 30 series NVIDIA cable. Struggling to get it to look neat with the tiny pins. Might have to heat shrink the ends and have that visible rather than going heatshrinkless on the braiding I've done.

Oh... I'm not getting that =/ edit: it is VERY close though 1-2mm at the most.

This looks very clean - In fact, have you been spying on me? I haven't finished my build but you have near enough done what I've done. (rads the other way around on mine) lol What coolant are you running? edit: I'm just waiting on another shipment of braid and cables (for my homemade PSU...

MDPC-X Splicing Solder-Shrink doesn't mention any power specs. Also not really a fan of the bullet butt crimps due to size and sleeving going over it. I think I'll give them a miss and just splice the old fashioned way. Time to dust off the old soldering iron

Ah my bad - yeah I saw that MDPC-X had them listed whilst I was browsing some of the different colour braids a while ago and was more curious than anything else. Yeah I remember braiding my old PSU ages back in 2013 (see sig) and was just thinking if there was a newer/easier way of doing things...

I'll be filling mine up this weekend with mystic fog... Any words of advice or is it pot luck if I get good or bad results :P

Just a quick question regarding making your own cables. I was going to splice and solder this weekend (if the remaining cable from my order arrives) the cables where two become one from the PSU into the 24 pin motherboard power cable. But then I came across these. Anyone have any...

Velcroing a DDC or D5? I drilled some holes where the PSU would go if in the lower possition and used some rubber HDD washers to act as vibration dampers. I have been away and only just got back so hopefully can finish my build this week.

Interesting, I went the other way around. What have you mounted your pump to if its above the PSU?

PSU in the upper position ?

Crazy isn't it that 6 new case fans can be more than the case they go in.