Search results

Where's the AMOLED screen from and what's the battery life like?

What setting do I need to change to stop having these lines in the middle of my flat surface prints? I’ve messed around with the surface and infill patterns Monotonic, Monotonic line and Aligned Rectilinear and still seem to get these obvious lines in the middle of the surface area Edit/...

I’ve not had any free time to do the Bambu Studio calibration and basic maintenance yet. If that doesn’t work then I’ll give them a call and see what they’ve got to say.

It just seems ridiculous after only 2 weeks. I didn’t service the Prusa MK3S+ once in 2 years!

Yup fairly liquid soapy water first and then 99% IPA after, still had the same issues. When I first got the P1S I didn't bother cleaning the plate, used it straight from the factory and prints came out perfect.

I haven't no, just the full calibration when you first set it up but I've only had it just over 2 weeks. Thanks, I'll give that try!

I was hoping not to but spray glue has resolved the adhesion issues, it's just annoying I didn't have this problem originally and all of a sudden now I do. Maybe the plate is warped slightly, I have been bending it to remove parts rather than using the scraper :-/ I need to try and resolve the...

That could be it, but it has been printing fine and then suddenly having loads of failures And also the top surface finish has drastically got worse, where I never had this issue before…

I'm starting to have a nightmare with mine, first two weeks printed perfectly and was the best thing ever, now not so much! In the last two days I've had more failed prints than I ever did with the Prusa in the last 2 years! :mad: Same filament, same settings, same model and the textured bed...

I placed order earlier, went with 0.2 and 0.8 in the end. I was going to get all four but 0.4 and 0.6 were out of stock. At some point I would like to give CF a go so I'll order the other two then and the gears.

Also, would you go for the Hotend assembly over the hotend with nozzle?

How do you find the 0.6? what kinda prints are you doing with it, any examples?

I've decided to pull the trigger on the P1S, is there any other accessories I should look to order at the same time to save on shipping later?

I keep all my filament with silca gel bags in my airing cupboard, never had issues with 'wet' filament before. I think it just needs a good clean and calibration of everything, it can't hurt right. I'm going to order a P1S now and will get round to sorting the Mk3S+ with Kilpper when I have...

Yeah, I always do a hot soapy water clean first to remove any residue built up over time, and then wipe with a paper towel & some IPA on to remove any finger prints. I don't normally wipe down with paper towel & IPA between every print, I was just doing it with the colour swatches to see if it...

I've tried printing 8 colour swatches all in the centre of the bed, cleaned with IPA between each print and with varying results. All PLA, 6 the same brand

Already done! It's not that I'm going to install Klipper, hopefully going through the calibration process of setting up Klipper will resolve it

Not yet but I've also been meaning to set it up with MiSTercast to watch some old VHS horror movies on my CRT.

It's a Prusa MK3S+

Thanks I’ll look into that