Search results

I'm running an Asus 9800GT on an Abit IP Pro Xe board and am unable to get a display out of it on the PCIE-1 slot. It runs ok on the second PCI-E slot but when connected to the first gives no output. (I using the same two DVI monitors in both cases.) I can run a 8600GS through slot 1 and get...

thanks - it was OCUK so I'll see what they say. If I do upgrade then any recommendations..? :)

crap - was hoping it wasn't! Thanks for the info...have even tried sweet talking it but hasn't worked either! :)

yup! and removed battery etc

I've got an IP35 pro running a Q6600 and 4Gb of RAM. It was working fine and now it fires up for 5 seconds and then shuts down with a 9.0 post code. I also notce the northbridge power light is showing as red. I've reduced the ram to one slot, swapped them around, removed all components except...

It's an SLACR. Yes, only booting with 1 DIMM so board is on bare minimum power requirements. Board is v1.0 but not sure of BIOS as can't POST. Definitely Pro XE not Pro.

Yeah, tried that too... Changed jumpers, removed battery for half an hour, reset etc but still no response. Think it's a RMA job... Thanks for suggestions - was just trying to confirm my suspicions...

Two 12v leads..? There's only the 8-pin 12v connector and the molex by the PCI/e slots, both of which are plugged in... Have stripped back the board to just be cpu & HSF and still get same error..?

Keep getting 8.7 error (low CPU voltage) at POST in my newly built machine. Have the following setup as per below and have used another new PSU and still get the same problem. Have removed HSF, cleaned, re-applied thermal paste and still get the same issue. Have also removed MB from case and...