420 and 240 rads in a Enthoo Primo

[FredBasset]

I'm looking for a case to house 420 and 240 rads with an E-ATX board and this res/pump combo

https://www.overclockers.co.uk/ek-w...40-revo-d5-pwm-incl.pump-glass-wc-9ec-ek.html

I quite like the white Primo as I intend to do a Martini Porsche theme to it. I will be using M2 drives so I don't need drive cages, is there sufficient room for the equipment in this case?

Thanks for any responses
Fred

 

[luffehamp]

I have the same case with a similar setup. There is plenty of space

https://i.imgur.com/EQPkXVO.jpg

Thick 240 push/pull at the bottom and a 480 in push/pull at the front. The whole front area is removable with a few screws allowing an entire empty area for play I have the pump in the rear but there is plenty of space up front if needs be.

 

[Kei]

Alphacool XT45's fit in my primo easily. Would be no issue having 60mm versions instead. XSPC photon 270 reservoir just fits on the bracket, but it really is just.

Pump hides in the stock mounting position but I took the bracket out as it causes too much vibration to get transferred to the chassis.