1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

coolit elite installation

Discussion in 'Overclocking & Cooling' started by zooankski, 12 Oct 2009.

  1. zooankski

    Hitman

    Joined: 6 Dec 2007

    Posts: 705

    Location: cambridge

    I have fitted the unit and am a little stuck with the wiring up.
    I cannot see a reference to a fan connector with just a red/black wire on it which comes from the unit. where does this plug in? to the mobo or spare connection on controller?
    Also i have searching usb on the software and no pump etc display. any ideas???
     
    Last edited: 12 Oct 2009
  2. zooankski

    Hitman

    Joined: 6 Dec 2007

    Posts: 705

    Location: cambridge

    Just a quick update: i plugged the connector directly in to the spare header on the control unit and nothing bad has happened so that is a bonus! I will try it direct to the mother board and fit my 120mm exhaust fan in it's place to see if that registers on the software program.
    I have re installed the software and now it seems to be working as it picks up the fan and pump ok.
    Has anyone else got one of these fitted to thier rig? if so then what did you make of it as i am actually quite impressed.
    My only gripe so far is that none of the tywrap tails have been cut off flush when it was made and i now have a nice cut to the back of my hand!