+44 (0)1782 44 44 55
RAI-BT Hard Tube Cutting & Bending Kit for 14mm TubingThe Raijintek cutting and bending kit contains all the necessary tools to handle hard tubes with 14 mm outside diameter perfectly and easily. This saves a lot of time, energy and annoyance when putting your water cooling system together. The tools enable precise cutting, clean deburring and comfortable bending of hard tubes.
The Raijintek Cutting and Bending Kit for Hard Tubes at a glance:
- Cutting and bending kit for hard tubes with 10 mm ID / 14 mm OD
- Cutting tool for cutting hard tubes
- Silicone hose for ideal bending support
- Three aluminum bending tools for 45 °, 90 °, 180 ° and 360 ° angles
- Deburring and countersinking tool for clean edges
The Raijintek cutting and bending kit for hard tubes in detail
The Raijintek cutting and bending kit consists of several useful tools that make the processing of hard tubes with 14 mm outside diameter comfortable and easy.
The Raijintek bending tube is inserted into the hard tube to be processed before heating. This will ensure that the diameter does not decrease or the tube kinks during the process. This ensures stability and even bending. The hose is suitable for hard tubes with an inner diameter of 10 millimeters.
Through the three enclosed angle piecesAlways clean bends occur at an angle of 0 to 360 °. The tools are specially optimized for tubes with an outside diameter of 14 millimeters. After inserting the bending tube into the hard tube, a heating gun or a hair dryer can be used to heat the material. To do this, only heat the area that should be bent at the end. Then bend the heated tube to the correct position using the desired bending tool and let it cool.
With the cutting tool , the bent tube can now be shortened according to requirements. For this purpose, the tube is simply clamped in the cutter and cut by rotation of the tool around the tube.
The deburring and countersinking toolthen ensures a perfect end result. Especially when cutting the tubes, bumps at the interface can occur again and again. With the aid of this small tool, the cutting edge can be deburred completely and smoothed accordingly, which visually not only looks better, but also for the fitting of a fitting is quite an advantage.
- Compatibility: PETG Hard Tubes with 10 / 14mm ID / OD (Inner Diameter / Outer Diameter)
- Bend hose: Silicone
- Elbows: Aluminum
- 3x contra-angles (45 ° & 90 °, 180 °, 360 °)
- 1x silicone
- hose 1x deburring and lowering tool
- 1x cutting tool
- Warranty: 2 years